Temperature Sensor using LM35 & IC741

Temperature Sensor circuit using LM35 & IC741

The Opamp IC 741 is used here as non-inverting non-zero reference comparator. Its inverting terminal is connected to variable voltage which can be adjusted with the help of variable resistor VR1.

The non inverting terminal is connected to the output of temperature sensor LM35.

The prototype works very effectively and responds to quick changes in temperature of LM35.

Temperature Sensor circuit using LM35 & IC741

Prototype of Temperature Sensor using IC741 & LM35
(Click to enlarge)

Circuit Details

  1. Pin 1 and pin 5 of IC 741 are left open.
  2. Pin 2 is connected to voltage divider using one fixed resistor of 2.2k and one variable resistor of 10k.
  3. Pin 3 is connected to the output pin i.e. middle pin of IC LM35.
  4. Pin 7 and pin are connected to +ve and -ve supply of 6V dual power supply.

The circuit is fully tested in our laboratory and works very nicely to measure the temperature from room temperature value to maximum of hot soldering iron temperature.

For any assistance and help, you can contact us on this link.

Write your comment here...